TriMark 050-0113 Two Rotor Latch Single-Position Intertrip

• Door thicknesses of 1-7/8″ or greater (47.6mm)
• Door weights of 50-200 lbs. (23-91 kg)
• Door seal pressures of 50-150 lbs. (23-68 kg)(suggested for best results)
• Use with TriMark 070-0200 Striker Bolt

AVAILABLE:

• In left or right hand configurations
• With (4) 1/4-20 UNC, M6 x 1 threaded axles or .286″ (7.3mm) diameter “thru” axles
• With trip lever options.

FINISH:

• Zinc plated, clear chromate steel components

MATERIAL:

• Internal latch components: heat treated, smooth edge stamped steel
• Case halves: high strength steel
• Springs: non-corrosive stainless steel

• (4) 1/4-20 UNC grade 5, M6 x 1 class 8.8 or better fasteners are required (not included).
• Tighten to the fastener manufacturers’ recommended torque value, however, do not exceed 120 in-lbs. (13.3 N-m)
• Fastener mounting holes diameter should not exceed .281″ (7.1 mm)

STRIKER INSTALLATION:

• Install striker bolt in door frame
• Close door carefully and check for interference between head of striker bolt and latch components
• Add or remove shims under striker bolt washer as required (outside diameter of shim should be larger than outside diameter of striker bolt washer)
• Adjust striker bolt vertically so door is not guided upward or downward while being closed
• CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
• Door should be latched but not “closed” in secondary position with respect to adjacent surfaces in primary position
• If both primary and secondary positions are not evident, readjust striker bolt
• After installation, check door alignment and door seal pressures

Individual part dimensions are for reference only. Refer to individual part drawings for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.

Caution: Single position rotary latches do not comply with FMVSS 206 (ECE R11) requirements.