TriMark 050-0210 Slimline Rotary Latch Single-Position

• Thinner, light or medium weight door applications
• Door weights up to 75 lbs. (34 kg)
• Door seal pressures of 20-25 lbs. (9-11 kg) recommended for best results. Not to exceed 50 lbs. (23 kg)
• Visible surface installation or concealed installation
• Applications where it is desireable to have a single position rotor latch
• Use with TriMark 070-0100 Striker Bolt

Available

• Left or right hand configurations
• With standard .265″ (6.7 mm) diameter “thru” axles as shown, 1/4-20 UNC threaded axles or M6 x 1.0 threaded axles

Finish

• Zinc plated, clear chromate steel components

Material

• Internal latch components: heat treated smooth edge stamped steel
• Springs: non-corrosive stainless steel
• Case halves: high strength steel

• (3) 1/4-20 UNC grade 5-type or M6 x 1 class 8.8 or better fasteners are recommended
• Vertical mounting with support ramp at top is required for proper alignment and subsequent engagement of locking pawl and striker bolt
• Tighten to the fastener manufacturers’ recommended torque value, however, do not exceed 120 in-lbs. (13.3 N-m)

Internal Lubrication

• Oven-cured dry lubricant is applied on all critical moving parts

Caution: Single position rotary latches do not comply with FMVSS 206 (ECE R11) requirements.